Long service life or improper operation of personnel are the reasons for the failure of the polishing machine. When the polishing machine fails, it will directly affect its use. Therefore, in order not to affect its normal use, it is necessary to carry out maintenance work in time. Then, how to replace the beam support roller of the polishing machine? The following polishing machine manufacturers will give specific maintenance plans.
Replacement of cross beam supporting roller of polishing machine
After the equipment has been used for a certain number of years, due to the frequent reciprocating swing of the beam, its supporting rollers are worn, which will cause mechanical movement failure, and must be replaced in an appropriate period. Before replacement, first purchase the required parts, prepare the required lifting tools or equipment, and carry out it with the assistance of professionals.
Use of polishing machine
Step: 1 Disassemble the support cover plates at both ends of the polishing machine; 2. Loosen the beam pressing mechanism; 3. Raise the beam with the lifting tool; 4. Take out the worn roller row and replace it with new parts; 5. Replace the lubricating oil in the support groove; 6. Reinstall the equipment.
Precautions: due to the large workload and difficulty of replacement, and the impact on production, the user must maintain the roller more, change the lubricating oil frequently, pay attention to water and slag prevention, and extend the service life of parts.
Regularly and regularly check the circuit of the polishing machine. If there are problems in the circuit of the polishing machine, such as exposed wires, short circuits, damaged devices, etc., they need to be replaced in time to prevent safety problems in the use of the polishing machine.
Check all parts of the equipment regularly, whether reinforced or functional. If there are loose parts, they should be reinforced immediately to prevent the parts from falling off during the operation of the polishing machine.
Regularly add lubricating oil to each part of the polishing machine or the oil filling hole. The existence of lubricating oil can reduce the friction between parts, delay the loss of parts, and increase the service life of parts, which can help reduce the maintenance cost of the polishing machine.
When these failures occur in the polishing machine, the solutions mentioned above can be used to carry out maintenance work, so as to ensure that the polishing machine equipment can be put into use as soon as possible. Since it is impossible to list the fault types one by one, if there are the fault types not mentioned above, don't panic, just seek the help of a professional maintenance unit.