1. Turn on the machine and unscrew the "emergency stop" button;
2. Adjust the water tank card position to properly clamp the water tank, record the data of each card position, and take pictures of the position of the caliper (Note: align the sink hole with the turntable ZX);
3. Number the program name and "reset" it to the original position;
4. Adjust the depth of the grinding wheel, pay attention to adjusting the lower limit position of the sensor and the position of the screw;
5. Clear the existing data "data to zero", press "debug stop", the "debug start" light is on, and the debugging starts, the steps are as follows:
① "Before the grinding wheel", move the grinding wheel forward to a proper position;
② "Workpiece positive" rotates the workpiece by a certain angle;
③ "After the grinding wheel", move the grinding wheel back to an appropriate position, so that the grinding wheel is in close contact with the arc of the water tank.
6. After completing the debugging of the polishing machine, "monitor" the data to check whether there is any abnormal data. If so, amend it;
7. After the correction is completed, press "Debug Start", the debugging start light is off, and the debugging is over; adjust it to "Auto", then "Reset", turn on "Auto Start", and try throwing the water tank;
8. Check the polishing effect, make corrections, and complete debugging.
Precautions for the use of polishing machines
First, the polishing machine should not be used if the following conditions are found:
1. The operator has not received professional training.
2. The operator has not learned the "safety operation procedures".
3. The polishing machine is not running normally.
Second, before using the polishing machine, the following checks should be done on the environment:
1. The operator's hands and feet should be kept away from the rotating polishing head.
2. The operator shall not step on the power cord or wrap the power cord into the polishing head.
3. The operator must dress safely.
4. The polishing area shall not exceed the length of the power cord.
5. The operator shall not let go of the operating handle without authorization.
6. When stopping, the handle must be released after the polishing machine has completely stopped rotating.
7. Do not use polishing pads with dust and dirt for polishing.
8. When the polishing pad with too much dirt cannot be cleaned, it should be replaced in time.
9. When replacing and installing the polishing pad, the power supply must be cut off.
Third, the storage of the polishing machine
1. Cut off the power.
2. Tilt backwards and store the rear wheels on the ground.
3. It should not be stored outdoors and should be stored in a dry place.
The polishing machine must pay attention to safety when operating it, because its rotating speed is very fast, so you must be very careful when operating it, otherwise it will cause serious unsafe factors to yourself. The use of a high-speed polishing machine requires professional training to operate, because it has a lot of points to pay attention to. If you don’t pay attention, there will be potential safety hazards. Therefore, you must be professionally checked during operation, so as to be responsible for your own safety.