News

Mechanical Seal Grinder Manufacturers Tell You: Analysis Of Pin Grinding Process Of Double-sided Grinder

Nov 14, 2021 Leave a message

The grinding process of mechanical seal grinder manufacturers is widely used in industry because it can produce high-quality and high-precision surfaces. Obtaining good process performance is more like artistic skills than scientific and technological achievements. Therefore, appropriate monitoring and control systems should be used to improve the productivity of expensive machine tools.

A proper definition of grinding recovery time is very important for the optimization and control of the overall grinding process. If the grinding discs are separated too late, the proper metal removal rate is not achieved, and even worse, the workpiece surface may be damaged. On the other hand, if dressing is applied too frequently, dressing diamond wear and grinding disc wear will cause huge cost. In the case of grinding classical dressings (i.e. discontinuities), it takes time to use unnecessary dressings, which increases the production cost.

The manufacturer of mechanical seal grinder tells you that in addition to cutting the workpiece surface, it can also be produced by friction during the vibration interaction between the grinding disc and the workpiece. Recent studies have shown that there is a strong correlation between surface conversion and emitted sound and vibration. Based on sound and vibration, skilled operation can detect whether the grinding wheel is sharp or dull.

The technology of operators of mechanical seal grinder manufacturers depends on people's ability to extract feature frequencies. During grinding, the frequency of sound ranges from 5000 to 10000 Hz and reflects the cutting profile. According to existing experience, the new grinding disc has a higher frequency throughout its life cycle. The particles on the grinding disc, the metal chips filled in the holes, and the distance between the grinding disc and the metal sheet increase the spacing of the grinding disc, resulting in larger wafers and higher surface roughness. Therefore, in the characteristic frequency range, the frequency is reduced to between 5000 and 6000Hz according to the abrasive particle size on the grinding disc.

In short, there are two sources of information about the current process status: vibration signal and expert judgment. Mechanical seal grinder manufacturers have been exploring the relationship between the characteristics of vibration signal and the performance grade evaluation time of experts to study the automatic control action.


Send Inquiry