Precautions for magnetic polishing machine
1 Do not spill liquid and water into the wires and plugs
2. The power supply of some magnetic polishing machines needs to be equipped with an over-current switch, and it is recommended to use 6A or more;
3. After turning on a power supply, pay attention to check whether the cold air cooling fan design of the back cover can operate normally
4. Some magnetic polishing machines should not be operated at low frequency for a long time. It should be noted that thunder and lightning may cause damage to the machine;
Instructions for use of magnetic polishing machine
1. Water level adjustment: In theory, less water can save polishing liquid during polishing, so it is recommended that the workpiece be large and light, and when it is heavy, it is recommended to increase the amount of water appropriately, which is beneficial to the floating of the workpiece.
2. Time adjustment: In the initial test, the time setting is determined by the product requirements. It can be adjusted for a long time. You can take out the product to check the polishing effect until you are satisfied. Write down the time at this time. After polishing, similar products are set according to this time.
3. Force (frequency) adjustment: The size of the force is directly proportional to the processing efficiency. The burr ability is strong, but it is easy to cast the surface of the workpiece into a mist (similar to sandblasting). But with reflection, the brightness will increase.
4 When using a magnetic polishing machine, we must ground the wire.